Absorbent carbon is widely applied not only at treatment of poisoning and intoxication. Popularly and effective use of coal in non-standard cases, for example for weight loss, bleaching of teeth and in care of skin. Today the site %hostof %will show what there areface packs to absorbent carbonas they influence skin and as to prepare them.
Impact of absorbent carbon on skin
Coal absorbs in itself toxins, harmful substances and pollution. As the sponge absorbs in itself all unnecessary. In face packs, coal works also — clears skin, pulls out dirt from a time, cleans black points and removes an inflammation. Absorbent carbon brings out of pollution skin, toxins which collected as a result of a natural exchange, and also settled on it from the polluted air. After masks skin pure and fresh, it as if shines! Regular application the detoksiruyushchikh of masks with absorbent carbon slows down aging of skin, cleans pores, levels complexion and removes inflammations.
It is desirable to do masks once a week or two, to combine with other masks and a peeling. It is impossible to store a ready mask therefore it needs to be applied directly after preparation. The mask is applied on the clean, steamed-out skin after use of a srub, so efficiency from a mask increases and you will be able to take pleasure in result after one application.
Face packs with absorbent carbon: recipes
Mask film with gelatin and coal
Effective mask which is capable to relieve of black points and the clogged-up pores. It is applied on zones which need to be cleared and removed black points. Usually it is the T-zone — a nose, a chin, a forehead. But also also drawing on all person, including a neck and area of a decollete is possible. It is required:
- Gelatin in granules — a teaspoon half;
- Milk — 1 teaspoon;
- Absorbent carbon — a tablet half;
The tablet needs to be crushed in powder, to mix with gelatin, to add milk and it is good to mix. Now it is necessary to heat mix that gelatin was dissolved. We put in a microwave for 15 seconds or we heat on a water bath so far gelatin completely won't be dissolved.
To apply a mask on the clean, steamed-out skin hot. We drive in the first layer into skin, from above we put the following layer. To hold a mask of 15-20 minutes before full drying. The mask turns into a film which needs to be removed from skin. Black points easily leave a time, the mask not only clears them, but also considerably narrows. Skin becomes pure and smooth.
Mask with clay and absorbent carbon
1 tablet of absorbent carbon to crush and mix with 1 tablespoon of cosmetic clay (how to choose clay on action you look here). To fill in with cool water (1 tablespoon) and carefully to mix to a uniform consistence. To apply a mask on clean skin, to hold 15 minutes then to wash away warm water. The mask with clay and coal clears and tightens skin, cleans and narrows pores.
Mask absorbent carbon and oil of a tea tree
To crush 2 tablets of absorbent carbon in powder, to part with 1 teaspoon of water and to add 1 teaspoon of lemon juice, to add 3 drops of essential oil of a tea tree. Carefully to mix mix. To apply a mask with a thin layer on clean skin, to hold 20 minutes then to wash away warm water and to wipe skin tonic.
Absorbent carbon and cocoa
Such mask is suitable for skin of any type, including the dry. To pound 1 tablet of absorbent carbon in powder, to mix with 1 teaspoon of powder of cocoa, to dissolve mix with 1 tablespoon of natural yogurt and carefully to mix. To warm up a mask to a warm state. To apply on clean skin, in 20 minutes to wash away warm water.
You already tried to do face packs with absorbent carbon? Share in comments!